Amana Range AER3311WA User Manual

30" (76 cm) Freestanding Electric Range  
PRODUCT MODEL NUMBERS  
PRODUCT DIMENSIONS  
AER3311WA  
AER5522VA  
AER5822VA  
AER5823XA  
AER5830VA  
AER5844VA  
AER6011VA  
Electrical: Range must be connected to the  
proper electrical voltage and frequency as  
specified on the model/serial number rating plate.  
The model/serial number rating plate is located  
behind the control panel or on the oven frame  
behind the storage drawer panel. Refer to the  
figures in the “Product Dimensions” section.  
A
B
This range is manufactured with the neutral  
terminal connected to the cabinet. Use a 3-wire,  
UL listed, 40- or 50-amp power supply cord  
(pigtail). If local codes do not permit ground  
through the neutral, use a 4-wire power supply  
cord rated at 250 volts, 40 or 50 amps and  
investigated for use with ranges.  
C
F
E
A circuit breaker is recommended.  
D
The range can be connected directly to the circuit  
breaker box (or fused disconnect) through  
flexible or nonmetallic sheathed, copper or  
aluminum cable.  
A. 27¹⁷⁄₃₂" (69.9 cm) max. depth with handle  
B. 46⁷⁄₈" (119.1 cm) overall height (max.) with leveling legs  
screwed all the way in*  
C. 36" (91.4 cm) cooktop height (max.) with leveling legs screwed  
all the way in*  
D. 29⁷⁄₈" (75.9 cm) width  
E. 25" (63.5 cm) depth  
F. Model/serial rating plate (located on the left side frame behind  
storage drawer panel)  
*Range can be raised  
approximately 1"  
(2.5 cm) by adjusting  
the leveling legs.  
CABINET OPENING DIMENSIONS  
Cabinet opening dimensions shown are for:  
25" (63.5 cm) countertop depth,  
24" (61 cm) base cabinet depth,  
36" (91.4 cm) countertop height  
A. 13" (33.0 cm) max. upper cabinet depth  
B. 30" (76.2 cm) min. opening width  
C. For minimum clearance to top of cooktop, see NOTE*.  
A
B
C
D. 30¹⁄₈" (76.5 cm) min. opening width  
E. Outlet - 8" (20.3 cm) to 22" (55.9 cm) from either cabinet,  
5¹⁄₂" (14.0 cm) max. from floor  
F. ⁷⁄₈" (2.2 cm) min. required between cutout and cabinet door or  
hinge.  
D
*
NOTE: 24" (61 cm) min. when bottom of wood  
or metal cabinet is protected by not less than 1/4" (6.4 mm)  
flame retardant millboard covered with not less than No. 28  
MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6  
mm) aluminum or 0.020" (0.5 mm) copper.  
E
30" (76.2 cm) min. clearance between the top of the cooking  
platform and the bottom of an unprotected wood or metal  
cabinet.  
F
Because Whirlpool Corporation policy includes a continuous commitment to improve our  
products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. W10252706A  
1/04/10  
 

ADC Network Card WBS 3190 User Manual
Addonics Technologies Computer Hardware AD2U3PCI User Manual
Advantek Networks Network Card AWN 11N PCI User Manual
Altec Lansing MP3 Docking Station iMT320 User Manual
BB Electronics Network Card EIR203 ST User Manual
BC Speakers Speaker 18P WB 46 User Manual
Behringer DJ Equipment PPA2000BT PPA500BT User Manual
Behringer Musical Instrument Amplifier BX4410 User Manual
Beko Freezer CFD 6913 APX User Manual
Eureka Tents Tent alpenlite 2XT User Manual