Amana Refrigerator 3UHSDUH User Manual

Amana cannot be responsible  
for improper installation.  
Attention Installer  
Shim refrigerator  
wheels as needed  
• Make sure cutout floor is level. If the floor is not  
level it is necessary to shim the rear wheels onto  
a piece of plywood or other shim material so  
refrigerator is level.  
!
WARNING  
To avoid electrical shock which can cause severe  
personal injury or death, disconnect power outlet  
from main power supply before installing or  
servicing refrigerator.  
!
CAUTION  
Some installations may require door removal to  
get the refrigerator into the home.  
1. Remove toe grille.  
2. Remove top hinge cover and top hinge.  
To avoid electrical shock which  
can cause severe personal  
injury or death, green ground wire  
B
.
must remain attached to hinge  
Dispensing and Electronic Models  
• Disconnect wire connectors.  
Loosen the water tube clamp (A). Loosen the  
water tube union nut (B). Pull the water tube  
away from the union nut and through the tube  
clamp.  
C
• Unplug electrical connector from voltage box (C).  
A
3. Remove doors.  
Remove top hinges.  
Remove doors from bottom hinge.  
Remove bottom hinge.  
4. Attach  
Top right  
refrigerator to  
appliance cart.  
Top left  
Bottom  
right  
!
Bottom  
left  
CAUTION  
To avoid floor and wall damage  
protect walls and soft vinyl or other  
flooring with masonite or other protective  
material when moving the refrigerator.  
"P" clamp  
1. Reinstall doors by performing section 2 in  
reverse order.  
Brass nut  
2. Connect ice maker water supply line. (Refer to  
Owner’s Manual)  
Copper  
tubing  
Loosen hinge screws  
Brass sleeve  
3. Plug power cord into electrical receptacle.  
4. Move refrigerator into final location.  
5. Once refrigerator is located and stable, level  
refrigerator by adjusting front, and rear (some  
models) cabinet leveling adjustment screws.  
6. Reconnect power from power source to electrical  
receptacle.  
2 turns counterclockwise  
Water valve  
inlet connection  
cabinet leveling  
adjustment screw  
7. Align doors.  
• To align tops of doors loosen the 2 bottom  
ALIGN  
right side hinge screws. Turn cam to raise or  
lower refrigerator door (Some models). (Refer  
to label inside refrigerator compartment on  
bottom mullion.)  
• Tighten the 2 hinge screws.  
8. Replace toe grille.  
Door alignment  
adjustment cam  
(some models)  
1. Remove all interior packaging material.  
2. Clean interior and exterior of refrigerator.  
3. Instruct consumer on controls and features.  
4. Verify power to refrigerator is connected.  
Part No. 12123312  
Printed in U.S.A.  
 

AB Soft Network Card MS6 SERIES User Manual
Adaptec Computer Hardware 2268300R User Manual
ADTRAN Network Card Internet Based WAN Backup User Manual
AEG Power Supply PROTECT 1100 User Manual
Aiphone Door EL 12S User Manual
ALS Industries CD Player DEH P5500MP User Manual
AmbiCom GPS Receiver BT GPS User Manual
American DJ Indoor Furnishings Titan User Manual
American Standard Outdoor Shower 8888120 User Manual
Axis Communications Car Video System P7216 User Manual